Sweco FMD-10LR Finishing Mill/Semi-Automatic Internal Separating Mill

Sweco FMD-10LR Finishing Mill

Semi-Automatic Internal Separating Mill

The FMD-10LR is equipped with semi-automatic parts-separating accessories which may be used to quickly and simply remove finished parts from the media at the end of the process cycle. The separating step is accomplished completely within the machine, and media need not be unloaded. Lowering of the dam interrupts the clockwise precession of the mass and causes it to climb in a helical pattern over the dam. The screen frame receives parts and media feeding over the dam. Media falls through the screen, remaining in the machine, while parts are conveyed across the screen and out of the unit onto the steel chute. Unloading cycle time is approximately 4-7 minutes, depending on parts load size.

Capacity: 10 ft³ (2500 lbs. load capacity)

Max Straight Part Length: 24 inches or more, depending on part cross-section and batch size

Chamber: 13 7/8" Maximum Width by 13 5/8" Depth. Abrasion-resistant lining of cast polyurethane with 3/4" minimum thickness in high wear areas.

Motion Generator: 2 hp Dayton, 1730 RPM, 3-phase 230 or 460 volt. 60 Hz.

Lining: Abrasion-resistant ¾" Cast Polyurethane

All welded steel construction, rigidly gusseted. Special features for low noise operation and minimum vibration transfer to floor.

6" x 12" manually operated discharge door.

Lever-operated 3" diameter drain with replaceable polyurethane grid, 1/8" grid openings. 1-1/2" drain hose connection.

Includes 116" X 14" Steel Chute

Ceramic Media

Shipping Weight: Approximately 1525 lbs.